take the clamp on mount for an old trolling motor{ just saw 2 on ebay} cut off a wood oar take the belt sander to it till it fits the hole drill a smal hole in the back of the housing to secure the oar to the trolling motor bracket..
u can tilt it up out of the way, make the paddle as long as u want.
http://cgi.ebay.com/ebaymotors/ws/e...RK:MEWA:IT&viewitem=&item=300050493858&rd=1,1
this is the one i was looking at
hope it helps

later
rich
u can tilt it up out of the way, make the paddle as long as u want.
http://cgi.ebay.com/ebaymotors/ws/e...RK:MEWA:IT&viewitem=&item=300050493858&rd=1,1
this is the one i was looking at
hope it helps
later
rich